The burr may be that the lens is dirty. At first, the lens is clean, so there is no problem in cutting. The back lens is dirty, so there are burrs. But the most fundamental reason is that the air used as auxiliary air is not clean and there is oil and water.
In this case, it is necessary to add water and oil removal equipment at the back end of air compressor to ensure the normal operation of cutting operation. In case of water removal, it is to increase the cold dryer, and in case of oil removal, it is to increase the rear end oil removal equipment.
In this way, the compressed air not only ensures the normal operation of the cutting operation, but also protects the laser cutting equipment. At the same time, it also extends the service life of the lens and the maintenance cycle of the laser cutting equipment. At the same time, the problem of oil and water pollution of the lens is avoided, which causes more damage to the laser equipment.
Laser cutting machine in the process of cutting as long as the correct method of operation is generally no problem, cutting effect is very good. But if you use the laser cutting machine to cut some burr, you need to pay attention to it. It is the best to find out the specific reason and solve it in time.
Laser cutting machine has been common in sheet metal processing. Due to its high efficiency and high cutting quality, laser cutting machine has become the standard configuration of sheet metal processing station. But some customers use laser cutting machine, cutting out of the workpiece burr, many people think it is the quality of laser cutting machine products, in fact, not necessarily.
In the process of sheet metal processing, the gas purity and parameter setting of laser cutting machine will affect the processing quality. If the equipment + gas + parameter is adjusted properly, the workpiece will be free of burr.
